Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2017 Hyundai Azera BaseFACTORY OEM SERVICE PROCEDURE

Door Outside Handle

Disconnect the front door outside handle connector (A).

Fig 1: Locating Front Door Outside Handle Connector
Courtesy of HYUNDAI MOTOR AMERICA

Check for continuity between terminals No 3 and No 6.

Standard value (Switch ON): 0 ~ 1 Ω

Fig 2: Checking For Continuity Between Terminals No 3 And No 6

Courtesy of HYUNDAI MOTOR AMERICA

No	Description
1	Door antenna (+)
2	Pocket lamp LED (+)
3	Door lock/unlock button switch
4	Door antenna (-)
5	Pocket lamp LED (-)
6	Door lock/unlock button switch ground

Fig 3: Checking Door Lock And Unlock Button Switch

Courtesy of HYUNDAI MOTOR AMERICA

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.