2017 Hyundai Accent Value EditionFACTORY OEM SERVICE PROCEDURE

Shift Lever Assembly Replacement

  1. Remove the center console.

    (Refer to CONSOLE )

  2. Disconnect the connector (A).
    G12019158Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the control cable (B).
    G12019159Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the shift lock cable (C) and key lock cable (B) by removing the nuts (A-2ea).

    Tightening torque:Β 

    9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

    G12019160Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the shift lever assembly (A) by removing the bolts (B-4ea).

    Tightening torque:Β 

    9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

    G12019161Courtesy of HYUNDAI MOTOR AMERICA
  6. Installation is the reverse of removal.
    NOTE: Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.