Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Hyundai Accent Value EditionFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
- Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
- Remove the battery and the battery tray.
(Refer to "CHARGING SYSTEM " .)
- Remove the air cleaner assembly.
(Refer to "INTAKE MANIFOLD " .)
- Remove the shift cable mounting nut (B).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 Kgf.m, 5.7 ~ 8.6 lb-ft)
- Disconnect the inhibitor switch connector (A).
- Remove the manual control lever (B) and the washer after removing a nut (A).CAUTION: When installing, affix the manual control lever and the inhibitor switch with Ø 5mm (0.1969in.). Then tighten the inhibitor assembly mounting bolts.
- Remove the inhibitor assembly (A) after removing the bolts (2ea).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
CAUTION: When installing, tighten the inhibitor assembly mounting bolt lightly, so that necessary adjustments can be made. Tighten to specifications.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.