Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2017 Hyundai Accent Value EditionFACTORY OEM SERVICE PROCEDURE

Connector Inspection Procedure

Handling of Connector
1. Never pull on the wiring harness when disconnecting connectors.
  
  Fig 1: Caution For Pulling Wiring Harness
  Courtesy of HYUNDAI MOTOR AMERICA
2. When removing the connector with a lock, press or pull locking lever.
  
  Fig 2: Pressing And Pulling Locking Lever
  Courtesy of HYUNDAI MOTOR AMERICA
3. Listen for a click when locking connectors. This sound indicates that they are securely locked.
  
  Fig 3: Locking Connectors
  Courtesy of HYUNDAI MOTOR AMERICA
4. When a tester is used to check for continuity, or to measure voltage, always insert tester probe from wire harness side.
  
  Fig 4: Caution For Measuring Voltage
  Courtesy of HYUNDAI MOTOR AMERICA
5. Check waterproof connector terminals from the connector side. Waterproof connectors cannot be accessed from harness side.
Fig 5: Caution For Waterproof Connector Terminals
Courtesy of HYUNDAI MOTOR AMERICA

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.