2016 Hyundai Veloster Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Smart Key Code Saving

  1. Connect the DLC cable of GDS to the Data Link Connector in driver side Crash Pad Lower Panel, turn the Power ON GDS.
    Fig 1: Locating Driver Side Crash Pad Lower Panel Data Link Connector
    G10605736Courtesy of HYUNDAI MOTOR AMERICA
  2. Select the vehicle model and then do "Smart Key Code Saving".
    Fig 2: Smart Key Code Saving - Screen Display (1 Of 9)
    G10605737Courtesy of HYUNDAI MOTOR AMERICA
  3. After selecting "Smart Key Teaching" menu, push "Enter" Key, then the screen will be displayed.
    Fig 3: Smart Key Code Saving - Screen Display (2 Of 9)
    G10605738Courtesy of HYUNDAI MOTOR AMERICA
  4. After pushing the SSB with the teaching Key, press "OK" button.
  5. Input the "Pin Code" for first Key teaching.
    Fig 4: Smart Key Code Saving - Screen Display (3 Of 9)
    G10605739Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.