2016 Hyundai Veloster Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Tailgate Switch

  1. Disconnect the Negative (-) Battery Terminal.
  2. Remove the Tailgate Outside Handle (A) after loosening the Mounting Nut (3EA).
    Fig 1: Tailgate Outside Handle
    G10605764Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the Tailgate Switch Assembly after loosening the Screw (2EA).
    Fig 2: Tailgate Switch Assembly Screws
    G10605765Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the Tailgate Switch after loosening the Screw (2EA).
    Fig 3: Loosening Tailgate Switch Screws
    G10605766Courtesy of HYUNDAI MOTOR AMERICA
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.