2016 Hyundai Veloster Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Tailgate Switch

  1. Check for continuity between the Trunk lid open switch terminals.

    [with Back View Camera]Β 

    Fig 1: Checking Continuity Between Trunk Lid Open Switch Terminals (With Back View Camera)
    G10605749Courtesy of HYUNDAI MOTOR AMERICA
    1. Ground
    2. Tailgate Switch

      [without Back View Camera]Β 

      Fig 2: Checking Continuity Between Trunk Lid Open Switch Terminals (Without Back View Camera)
      G10605750Courtesy of HYUNDAI MOTOR AMERICA
      1. Ground (Tailgate)
      2. Tailgate Switch
      3. Ground (Back View Camera)
      4. Power
      5. V-OUT
      6. V-GND
  2. If continuity is not specified, inspect the switch
    Fig 3: Trunk Lid Open Switch Terminals Continuity Chart
    G10605751Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.