2016 Hyundai Veloster Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Disconnect the Negative (-) Battery Terminal.
  2. Remove the Driver Airbag Module.

    (Refer to: RT procedure - "Driver Airbag Module and Clock Spring").

  3. Remove the Steering Wheel.

    (Refer to: RT procedure - "STEERING COLUMN & SHAFT ").

  4. Remove the Steering Wheel Cover (A) after loosening 4 Screws.
    Fig 1: Steering Wheel Cover Screws
    G10605686Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the Steering Wheel Remote Control Switches Connectors.

    [LH-Audio/Bluetooth + Voice]Β 

    Fig 2: Steering Wheel Remote Control Switches Connectors (LH-Audio/Bluetooth And Voice)
    G10605687Courtesy of HYUNDAI MOTOR AMERICA

    [RH-Cruise/Trip + Reset]Β 

    Fig 3: Steering Wheel Remote Control Switches Connectors (RH-Cruise/Trip And Reset)
    G10605688Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the Wiring and loosen 5 Screws.
  7. Remove the Steering Wheel Remote Control Switch Assembly (A).
    Fig 4: Steering Wheel Remote Control Switch Assembly
    G10605689Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the Bluetooth Switch and the Trip Switch (A) after loosening the screws.
    Fig 5: Bluetooth Switch And Trip Switch Screws
    G10605690Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.