Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Hyundai Veloster Base, Standard TransFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Inspection
- Check the Audio Remote Control Switch (A) for resistance between Connector Terminals in each Switch Position.
[LH-AUDIO]
Courtesy of HYUNDAI MOTOR AMERICA
[RH-TRIP]
Courtesy of HYUNDAI MOTOR AMERICA
CONNECTOR TERMINAL DESCRIPTION (AUDIO)Switch Connector Terminal Resistance (± 5%) Seek up 3-5 430 Ω Seek down 3-5 1.11 kΩ Mode 3-5 2.11 kΩ Volume up 3-5 4.61 kΩ Volume down 3-5 6.81 kΩ CONNECTOR TERMINAL DESCRIPTION (CRUISE)Switch Connector Terminal Resistance (± 5%) ON/OFF 3-4 880 Ω Cancel 3-4 180 Ω SET - 3-4 330 Ω SET + 3-4 550 Ω CONNECTOR TERMINAL DESCRIPTION (BLUETOOTH + VOICE)Switch Connector Terminal Resistance (± 5%) Voice 3-4 10.71 kΩ End of Call 3-4 18.91 kΩ Send 3-4 40.91 kΩ CONNECTOR TERMINAL DESCRIPTION (TRIP + RESET)Switch Connector Terminal Resistance (± 5%) Trip 3-4 2.54 kΩ Reset 3-4 5.54 kΩ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
