2016 Hyundai Tucson SE, FWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the steering wheel assembly.

    (Proceed to Steering System - "STEERING WHEEL ")

  3. Remove the screws from the steering back cover (A).
    Fig 1: Removing Screws From Steering Back Cover
    G11669760Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the steering remote control connector (A).
    Fig 2: Removing Steering Remote Control Connector
    G11669761Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the steering remote control (A) after loosening the screws.
Fig 3: Removing Steering Remote Control Screws
G11669762Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.