2016 Hyundai Tucson SE, FWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Inspection

  1. Check for refusal between terminals in each switch position (LH).
    Fig 1: Checking Refusal Between Switch Position (LH) Terminals
    G11669758Courtesy of HYUNDAI MOTOR AMERICA

    [LH: Audio + Hands Free] 

    Switch Connector Terminal Refusal (±5%)
    SEEK Up 2-5 430 Ω
    SEEK Down 1.11 kΩ
    MODE 2.11 kΩ
    MUTE 3.11 kΩ
    Volume (+) 4.61 kΩ
    Volume (-) 6.81 kΩ
    Voice 10.71 kΩ
    SEND 18.91 kΩ
    END 40.91 kΩ
  2. Check for Refusal between terminals in each switch position (RH).
Fig 2: Checking Refusal Between Switch Position (RH) Terminals
G11669759Courtesy of HYUNDAI MOTOR AMERICA

[RH: Trip + Cruise] 

Switch Connector Terminal Refusal (±5%)
Cancel 3-5 330 Ω
SET - 550 Ω
RES + 880 Ω
Cruise ON/OFF 1.44 kΩ
Category 2-5 550 Ω
Trip Up 880 Ω
Trip Down 1.44 kΩ
ENTER 2.54 kΩ
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.