2016 Hyundai Sonata Plug-In HybridFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Disconnect a boots from the console upper cover.
  2. Pull the knob (A) in the direction of "F" and remove the knob.
    Fig 1: Pulling Shift Lever Knob
    G11631367Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the floor console assembly. (Refer to Body - "Floor Console ")
  4. Remove the air duct (A).
    Fig 2: Locating Shift Lever Air Duct
    G11631368Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the connector (A) from the shift lever.
    Fig 3: Shift Lever Connector Location
    G11631369Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the control cable (A).
    1. Disconnect the cable holer (A) from the shift lever.
    2. Disconnect the cable bracket from the shift lever after pushing the lock.
    Fig 4: Disconnecting Control Cable
    G11631370Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the bolts and then shift lever assembly (A).

    Tightening torque:Β 

    8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Fig 5: Removing Shift Lever Assembly Bolts
    G11631371Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the P position switch mounting bracket (A).
    Fig 6: P Position Switch Mounting Bracket
    G11631372Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the P position switch (A) and shift lock solenoid (B).
    Fig 7: P Position Switch And Shift Lock Solenoid Location
    G11631373Courtesy of HYUNDAI MOTOR AMERICA
  10. Disconnect the manual mode switch housing (A).
    Fig 8: Manual Mode Switch Housing
    G11631374Courtesy of HYUNDAI MOTOR AMERICA
  11. Disconnect the main connector (A) from the shift lever.
    Fig 9: Locating Shift Lever Main Connector
    G11631375Courtesy of HYUNDAI MOTOR AMERICA
  12. P position switch, shift lock solenoid, manual mode switch housing, main connector assembly (A).
    Fig 10: Shift Lever Main Connector Assembly
    G11631376Courtesy of HYUNDAI MOTOR AMERICA
  13. Remove the mounting bracket (A) of terminals from the main connector.
    Fig 11: Main Connector Mounting Bracket
    G11631377Courtesy of HYUNDAI MOTOR AMERICA
  14. Remove each terminals (F) of the P position switch (A), shift lock solenoid (B), manual mode switch housing (C) after released lock (E) from the main connector (D).
    CAUTION:
    • Record the location of the wiring colors before disconnecting the terminals.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.