2016 Hyundai Sonata Plug-In HybridFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

WARNING: This page is about a different car, the 2016 Hyundai Elantra GT and 2015 Hyundai Elantra GT. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
    Fig 1: Identifying Accelerator Position Sensor Connector
    G10749906Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the installation bolt (B), the nuts (C) and then remove the accelerator pedal module.
    Fig 2: Identifying Accelerator Pedal Module Installation Bolt
    G10749907Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.