2016 Hyundai Santa Fe XL BaseFACTORY OEM SERVICE PROCEDURE

Repair procedures: Removal

CAUTION: When installing a used TCM on a vehicle with immobilizer, the following procedure must be performed.

In the case of installing used TCM 

  1. Perform "TCM Neutral mode" procedure with GDS.

    (Refer to "IMMOBILIZER SYSTEM ")

  2. After finishing "TCM Neutral mode", perform "Key teaching" procedure with GDS.

    (Refer to "IMMOBILIZER SYSTEM ")

In the case of installing new TCM 

Perform "Key teaching" procedure with GDS.

(Refer to "IMMOBILIZER SYSTEM ")

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.