Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Hyundai Santa Fe XL BaseFACTORY OEM SERVICE PROCEDURE
Body Control Module (BCM) DTCS
BODY CONTROL MODULE (BCM) DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B121000 | Front Left Sensor Fault |
| DTC B121100 | Front Center Left Sensor Fault |
| DTC B121200 | Front Center Right Sensor Fault |
| DTC B121300 | Front Right Sensor Fault |
| DTC B121400 | Rear Left Sensor Fault |
| DTC B121500 | Rear Center Left Sensor Fault |
| DTC B121600 | Rear Center Right Sensor Fault |
| DTC B121700 | Rear Right Sensor Fault |
| DTC B160300 | CAN Bus OFF (B-CAN) |
| DTC B160500 | CAN timeout between IPM and DDM |
| DTC B160600 | CAN timeout between IPM and ADM |
| DTC B160900 | CAN Time-out SJB, FSJB |
| DTC B168A00 | CAN Time-out SMK |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
