2016 Hyundai Santa Fe XL BaseFACTORY OEM SERVICE PROCEDURE

Repair procedures: Removal

CVVT Oil Control Valve - Intake 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the intake manifold.

    (Refer to "INTAKE MANIFOLD ")

  3. Disconnect the CVVT oil control valve connector (A).
  4. Remove the installation bolt (B), and then remove the valve from the engine.

    Bank 1 

    Fig 1: CVVT Oil Control Valve Connector And Installation Bolt - Bank 1
    G10574943Courtesy of HYUNDAI MOTOR AMERICA

    Bank 2 

    Fig 2: CVVT Oil Control Valve Connector And Installation Bolt - Bank 2
    G10574944Courtesy of HYUNDAI MOTOR AMERICA

CVVT Oil Control Valve - Exhaust 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the CVVT oil control valve connector (A).

    Bank 1 

    Fig 3: CVVT Oil Control Valve - Exhaust, Bank 1
    G10574945Courtesy of HYUNDAI MOTOR AMERICA

    Bank 2 

    Fig 4: CVVT Oil Control Valve - Exhaust, Bank 2
    G10574946Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the cylinder head cover.

    (Refer to "CYLINDER HEAD COVER ")

  4. Remove the installation bolt (A), and then remove the valve from the engine.

    Bank 1 

    Fig 5: CVVT Oil Control Valve Installation Bolt - Bank 1
    G10574947Courtesy of HYUNDAI MOTOR AMERICA

    Bank 2 

    Fig 6: CVVT Oil Control Valve Installation Bolt - Bank 2
    G10574948Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.