Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Hyundai Genesis 5.0FACTORY OEM SERVICE PROCEDURE

Repair procedures: Removal

Remove the nut (B) and clip (C).
Remove the shift cable (A) assembly from the transmission.
Tightening torque:

12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

Fig 1: Transmission Shift Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the floor console.
(Refer to "FLOOR CONSOLE ")
Disconnect the shift cable (A) from the shift lever.

Fig 2: Shift Cable And Lever
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable assembly (B) by removing the nuts (A).
Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Fig 3: Shift Cable Assembly And Nuts
Courtesy of HYUNDAI MOTOR AMERICA
Pull the rubber plug from the floor and pull out the shift cable assembly.

Chapter Navigation

Return to Chapter: Repair procedures

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.