2016 Hyundai Genesis 5.0FACTORY OEM SERVICE PROCEDURE

Repair procedures: Adjustment

How to Adjust Shift Cable 

  1. Insert the shift cable to the bracket and hold it with a new clip.
  2. Align the manual lever hole to the hole on the transmission case and hold the position with a bar.
  3. Eliminate shift cable free play of the shift cable.
  4. Firmly hold the special bolt with a wrench and tighten the nut (A) to the specified torque.

    Tightening torque: 

    13 ~ 16 N.m (1.3 ~ 1.6 kgf.m, 9.40 ~ 11.57 lb-ft)

    Fig 1: Tightening Nut Using Wrench
    G10452529Courtesy of HYUNDAI MOTOR AMERICA
  5. Take off the bar holding the manual lever.
  6. Shifting each position, check if the shift lever moves smoothly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.