Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Hyundai Genesis 5.0FACTORY OEM SERVICE PROCEDURE

Repair procedures: Removal

Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the ECM & TCM & IDB cover (A).

Fig 1: ECM, TCM And IDB Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the ECM connector (A), and then disconnect the IDB connector (B) and the TCM connector (C).

Fig 2: ECM, TCM And IDB Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Remove the ECM & TCM & IDB bracket installation bolts (A) and nut (B).

Fig 3: ECM, TCM And IDB Bracket Installation Bolts And Nut
Courtesy of HYUNDAI MOTOR AMERICA
After removing the installation bolts (A), remove the TCM (B) from the bracket.

Fig 4: TCM Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
After removing the installation nuts (A), remove the IDB (B) from the bracket.

Fig 5: IDB Mounting Nuts
Courtesy of HYUNDAI MOTOR AMERICA

Chapter Navigation

Return to Chapter: Repair procedures

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.