Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Hyundai Genesis 3.8, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

Bank 1

WARNING:

DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. In this case, the hot engine oil could lead or cause burns.

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the intake hose.
(Refer to "AIR CLEANER ")
Disconnect the camshaft position sensor connector (A).
Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.
Bank 1/Intake

Fig 1: Camshaft Position Sensor And Connector (Bank 1/Intake)
Courtesy of HYUNDAI MOTOR AMERICA

Bank 1/Exhaust

Fig 2: Camshaft Position Sensor And Connector (Bank 1/Exhaust)
Courtesy of HYUNDAI MOTOR AMERICA

Bank 2
WARNING:
- DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. In this case, the hot engine oil could lead or cause burns.
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Remove the surge tank.
  (Refer to "SURGE TANK ")
3. Disconnect the camshaft position sensor connector (A).
4. Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.
  Bank 2/Intake
  
  Fig 3: Camshaft Position Sensor Connector And Mounting Bolt (Bank 2/Intake)
  Courtesy of HYUNDAI MOTOR AMERICA
  
  Bank 2/Exhaust
  
  Fig 4: Camshaft Position Sensor Connector And Mounting Bolt (Bank 2/Exhaust)
  Courtesy of HYUNDAI MOTOR AMERICA

Chapter Navigation

Return to Chapter: Repair Procedures

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.