2016 Hyundai Equus SignatureFACTORY OEM SERVICE PROCEDURE

Signal Waveform & Data

Fig 1: Scantool Display - Signal Waveform Of CAN Communication
G10391495Courtesy of HYUNDAI MOTOR AMERICA

Monitoring CAN HIGH and LOW simultaneously is important in monitoring CAN communication waveform. When CAN HIGH signal rise to 3.5V and LOW signal drops to 1.5V - voltage difference between HIGH and LOW signal is 2V - at BUS IDLE state (DIGITAL "1") whose reference voltage is 2.5V, "0" is recognized. Besides, comparing HIGH and LOW signal if opposite waveform is detected with the reference voltage of 2.5V, Check if current CAM signal is transfers correctly.

Continuous "0"'signal above 6 BIT means the occurrence of error in CAN communication. BIT is easily distinguished as calculating the time when "OF" (START OF FRAME) which notifies the start of frame occurs. Check if "0"'signal above 6 BIT is detected continuously when monitoring CAN communication waveform.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.