Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
General Information - Engine Control/ Fuel System - 1.8L: Specifications: Actuators: Notes
Injector
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 13.8 ~ 15.2 [20°C (68°F)] |
ETC Motor [integrated into ETC Module]
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 0.3 ~ 100 [20°C (68°F)] |
Purge Control Solenoid Valve (PCSV)
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 22.0 ~ 26.0 [20°C (68°F)] |
CVVT Oil Control Valve (OCV)
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 9.4~10.4 [20°C (68°F)] |
Variable Intake Solenoid (VIS) Valve
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 30.0 ~ 35.0 [20°C (68°F)] |
Variable Charge Motion Actuator (VCMA)
- Specification
[Motor]
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 3.4 ~ 4.4 [20°C (68°F)] |
[Position Sensor]
| Item | Specification |
|---|---|
| Coil Resistance (kΩ) | 3.44 ~ 5.16 [20°C (68°F)] |
Ignition Coil
- Type: Stick type
- Specification
| Item | Specification |
|---|---|
| Primary Coil Resistance (Ω) | 0.75 ± 15% [20°C (68°F)] |
| Secondary Coil Resistance (kΩ) | 5.9 ± 15% [20°C (68°F)] |
Canister Close Valve (CCV)
- Specification
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 19.9 ~ 22.9 [20°C (68°F)] |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.