2016 Hyundai Elantra GT Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the floor console assembly.

    (Refer to: Body - "FLOOR CONSOLE ").

  2. Remove the air duct (A).
    Fig 1: Removing Air Duct
    G10750119Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.
    Fig 2: Removing Select Cable Snap Pin
    G10750120Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the shift cable (B) after removing the clip (A).
    Fig 3: Removing Shift Cable
    G10750121Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the cable guide (A) from lever assembly after pulling in the direction of the marker.
    Fig 4: Removing Cable Guide From Lever Assembly
    G10750122Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the crash pad and cowl cross bar.

    (Refer to: Body - "COWL CROSS BAR ASSEMBLY ").

  7. Remove the heater unit.

    (Refer to: Heating, Ventilation, Air Conditioning - "HEATER UNIT ").

  8. Remove the retainer (A) after loosen the nut (B).
    Fig 5: Removing Retainer Nut
    G10750123Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the following parts.
    1. Engine cover.

      (Refer to: Engine Mechanical System - "ENGINE COVER ").

    2. Air cleaner assembly and air duct.

      (Refer to: Engine Mechanical System - "AIR CLEANER ").

    3. Battery and battery tray.

      (Refer to: Engine Electrical System - "BATTERY ").

  10. Remove the shift & select cable.
    1. Remove the pin (A) and washer (B).
    2. Make unlock clip (C) and then remove the shift & select cable and the clip (C) from the bracket.
      Fig 6: Removing Pin, Washer And Shift & Select Cable Clips
      G10750124Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.