2016 Hyundai Elantra GT Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

CAUTION:
  • When installing, set room side Shift lever and T/M side lever to 'N' position.
  1. Install the control cable (B) and clip (A) on the bracket.
    Fig 1: Removing Control Cable And Clip On Bracket
    G10750125Courtesy of HYUNDAI MOTOR AMERICA
  2. Install the washer (B) and pin (A).
    Fig 2: Removing Washer And Pin
    G10750126Courtesy of HYUNDAI MOTOR AMERICA
  3. Tighten the nut (B) after install the retainer (A).

    Tightening Torque:Β 

    11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

    Fig 3: Installing Retainer
    G10750127Courtesy of HYUNDAI MOTOR AMERICA
  4. Install the crash pad and cowl cross bar.

    (Refer to: Body - "COWL CROSS BAR ASSEMBLY ").

  5. Install the heater unit.

    (Refer to: Heating, Ventilation, Air Conditioning - "HEATER UNIT ").

  6. Install the cable guide (B) on lever assembly.
    Fig 4: Installing Cable Guide On Lever Assembly
    G10750128Courtesy of HYUNDAI MOTOR AMERICA
  7. Install the shift cable (B) and clip (A).
    Fig 5: Installing Shift Cable And Clip
    G10750129Courtesy of HYUNDAI MOTOR AMERICA
  8. Shift lever to "3rd".
  9. Install the snap pin (A) after install the select cable (B).
    CAUTION:
    • Install the snap pin (A) after adjust the select cable (B).

      (Refer to: "ADJUSTMENTΒ  Control Cable").

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.