2016 Hyundai Elantra GT Automatic TransFACTORY OEM SERVICE PROCEDURE

Select Cable Adjustment

  1. Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.
    Fig 1: Removing Select Cable Snap Pin
    G10750132Courtesy of HYUNDAI MOTOR AMERICA
  2. Shift the shift lever to 3rd gear.
  3. Move the slide clip (B) of guide member (A) in the direction as displayed in the graphic.
    Fig 2: Moving Slide Clip Of Guide Member
    G10750133Courtesy of HYUNDAI MOTOR AMERICA
  4. Install the select cable (A).
    Fig 3: Installing Select Cable
    G10750134Courtesy of HYUNDAI MOTOR AMERICA
  5. Insert the slide clip (A) in the direction as displayed in the graphic and then install the snap pin (B).
    Fig 4: Inserting Slide Clip And Snap Pin
    G10750135Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.