2016 Hyundai Elantra GT Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the floor console.

    (Refer to: Body - "FLOOR CONSOLE ASSEMBLY ").

  2. Disconnect the connector (A).
    Fig 1: Identifying Connector
    G10750279Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the shift control cable (A).
    Fig 2: Locating Shift Control Cable
    G10750280Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the AT lever (Shift Lever) assembly (A) by removing the bolts (4EA).

    Tightening Torque:Β 

    8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Fig 3: Removing AT Lever (Shift Lever) Assembly
    G10750281Courtesy of HYUNDAI MOTOR AMERICA
  5. Installation is the reverse of removal.
    NOTE: Make sure vehicle Does Not roll before setting room side shift lever and Automatic Transaxle (AT) side.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.