2016 Hyundai Elantra GT Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the floor console assembly.

    (Refer to: Body - "FLOOR CONSOLE ASSEMBLY ").

  2. Remove the control cable (A).
    Fig 1: Identifying Control Cable
    G10750283Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the main crash pad.

    (Refer to: Body - "MAIN CRASH PAD ASSEMBLY ").

  4. Remove the heater unit.

    (Refer to: Heater - "HEATER UNIT ").

  5. Remove the retainer (A) and nuts (B).

    Tightening Torque:Β 

    9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

    Fig 2: Identifying Retainer And Nuts
    G10750284Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the nut (C).

    Tightening Torque:Β 

    9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)

  7. Remove the cable (B) from the bracket (A) at transaxle assembly side.
    Fig 3: Identifying Transaxle Assembly Bracket
    G10750285Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the control cable inside of cab.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.