2016 Hyundai Elantra GT Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Make sure vehicle Does Not roll before setting room side shift lever and T/M Side Manual Control Lever to "N" position.
  2. Disconnect the negative (-) battery cable.
  3. Remove the air cleaner assembly.

    (Refer to: Engine Mechanical System - "AIR CLEANER ").

  4. Remove the shift cable mounting nut (B).

    Tightening Torque:Β 

    9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)

  5. Disconnect the inhibitor switch connector (A).
    Fig 1: Identifying Inhibitor Switch Connector And Shift Cable Mounting Nut
    G10750275Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the Manual Control Lever (B) and the washer after removing a nut (A).
    Fig 2: Identifying Manual Control Lever And Nut
    G10750276Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.