2016 Hyundai Elantra GT Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad center garnish (A).
    Fig 1: Identifying Crash Pad Center Garnish
    G10751842Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the crash pad lower panel (A).
    Fig 2: Removing Crash Pad Lower Panel
    G10751843Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the steering column shroud lower and upper panel (A) after loosening 3 screws.
    Fig 3: Loosening Steering Column Shroud Lower And Upper Panel Screws
    G10751844Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.