2016 Hyundai Azera BaseFACTORY OEM SERVICE PROCEDURE

Repair procedures: Removal

  1. Remove the automatic transaxle assembly.

    (Refer to "AUTOMATIC TRANSAXLE ")

  2. Remove the air breeder hose (A).
  3. Remove the valve body cover (B).

    Tightening torque:Β 

    12.8 ~ 14.7 N.m (1.3 ~ 1.5 kgf.m, 9.4 ~ 10.9 lb-ft)

    Fig 1: Valve Body Cover And Air Breeder Hose
    G10367707Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).

    Tightening torque:Β 

    9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Fig 2: Solenoid Valve Connector And Oil Temperature Sensor Connector
    G10367708Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the solenoid valve support bracket (B) and the valve body mounting bolt (A-1ea).

    Tightening torque:Β 

    9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Fig 3: Valve Body Mounting Bolt
    G10367709Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the torque converter control solenoid valve (A).
    Fig 4: Torque Converter Control Solenoid Valve
    G10367710Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.