2016 Hyundai Azera BaseFACTORY OEM SERVICE PROCEDURE

Items to check

  1. Inspect DTC code.
  2. Inspect whether N setting matches.
    1. Adjust N setting (refer to "INHIBITOR SWITCH ")
  3. Inspect shift cable separation.
    1. Adjust shift cable separation (refer to "SHIFT CABLE ")
  4. Inspect whether connector is connected.
    1. Inspect connector thoroughly for looseness, poor connection, bending, corrosion, contamination, deformation, or damage.
    2. Turn ignition key "ON" and engine "OFF" and measure the power supplied to inhibitor switch circuit and voltage between ground.

      Specification: approx. 12 V

    3. Fix the pin wiring when connector pin wiring is faulty. .
  5. Inspect ground condition on reversing light circuit.
    1. Check the ground location of reversing light (refer to appropriate SYSTEM WIRING DIAGRAM article ).
    2. Reattach reversing light if ground condition is faulty.
  6. Inspect wiring connection on junction box power terminal and fuse lamp.
    1. Check whether fuse holder is separated and holder is holding the fuse tight.
      Fig 1: Fuse Terminals Gap
      G10367741Courtesy of HYUNDAI MOTOR AMERICA
    2. Attach tester fuse to check if it is connected appropriately.
      Fig 2: Tester Fuse
      G10367742Courtesy of HYUNDAI MOTOR AMERICA
    3. Check whether fuse capacity is appropriate for each circuit.
    4. Check if fuse is damaged.
    5. Check pulling of fuse fixing wiring, inflow of foreign substance, and arrangement condition of terminal.
    6. Relocate the terminal that has been pulled and inspect using the method explained above.
    7. When problem is not solved, refer to the circuit diagram wiring repair instructions to fix or replace the terminal.
  7. Inspect inhibitor switch signal.
    1. Turn ignition key "ON" and engine "OFF".
    2. Measure the voltage between each terminal and chassis ground when shifting lever to "P, R, N, D" range.

      Specified value: refer to specification "SIGNAL CODE " table

Chapter Navigation
Return to Chapter: Inspection
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.