Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Hyundai Azera BaseFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle System Diagnosis
- DTC Index
- DTC P0601: Internal Control Module Memory Check Sum Error
- DTC P0705: Transmission Range Sensor Circuit Malfunction
- DTC P0706: Shift Cable alignment error between TGS Lever and Transmission Range Sensor
- DTC P0712: Transmission Fluid Temperature Sensor 'A' Circuit Low Input
- DTC P0713: Transmission Fluid Temperature Sensor 'A' Circuit High Input
- DTC P0717: Input/Turbine Speed Sensor 'A' Circuit No Signal
- DTC P0722: Output Speed Sensor Circuit No Signal
- DTC P0731: Gear 1 Incorrect Ratio
- DTC P0732: Gear 2 Incorrect Ratio
- DTC P0733: Gear 3 Incorrect Ratio
- DTC P0734: Gear 4 Incorrect Ratio
- DTC P0735: Gear 5 Incorrect Ratio
- DTC P0729: Gear 6 Incorrect Ratio
- DTC P0741: Torque Converter Clutch Circuit Performance or Stuck Off
- DTC P0743: Torque Converter Clutch Circuit Electrical
- DTC P0748: Pressure Control Solenoid Valve (VFS) 'A' Electrical
- DTC P0753: Shift Control Solenoid Valve 'A' Electrical (UD/B)
- DTC P0758: Shift Control Solenoid Valve 'B' Electrical (2-6/B)
- DTC P0763: Shift Control Solenoid Valve 'C' Electrical (35R/C)
- DTC P0768: Shift Control Solenoid Valve 'D' Electrical (OD/C)
- DTC P0773: Shift Control Solenoid Valve 'E' Electrical (SS-A)
- DTC P0880: TCM Power Signal Error Open/Short (GND)
- DTC P0955: Auto Shift Manual Mode Circuit
- DTC P2709: Shift Control Solenoid Valve 'F' Electrical (SS-B)
- DTC U0001: High Speed CAN Communication Bus off
- DTC U0100: Lost Communication With ECM/PCM 'A'
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
