Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Hyundai Azera BaseFACTORY OEM SERVICE PROCEDURE

Repair procedures: Installation

Install the jack to the edge of upper oil pan to support the engine.
NOTE: Insert the rubber block between jack and upper oil pan.
The key (A) of crankshaft should be aligned with the timing mark (B) of block. As a result of this, the piston of No. 1 cylinder is placed at the top dead center on compression stroke.

Fig 1: Crankshaft Key
Courtesy of HYUNDAI MOTOR AMERICA
Install the tensioner adapter assembly (A).

Fig 2: Tensioner Adapter Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Install the crankshaft sprocket (A). (LH camshaft drive).

Fig 3: Crankshaft Sprocket (LH Camshaft Drive)
Courtesy of HYUNDAI MOTOR AMERICA
Install the LH timing chain (A).

Fig 4: LH Timing Chain
Courtesy of HYUNDAI MOTOR AMERICA

Chapter Navigation

Return to Chapter: Repair procedures

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.