Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Hyundai Azera BaseFACTORY OEM SERVICE PROCEDURE
Repair procedures: Removal
- Remove the driver airbag module.
(Refer to "DRIVER AIRBAG (DAB) MODULE AND CLOCK SPRING ")
- Remove the steering wheel.
(Refer to "STEERING COLUMN AND SHAFT ")
- Remove the steering wheel cover (A) after loosening the screws.
- Remove the steering wheel remote control switch connector (A).
[LH - AVN/Handsfree]
Courtesy of HYUNDAI MOTOR AMERICA
[RH - Cruise]
- Remove the steering wheel remote control switch (A) after loosening the mounting screws.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.