2016 Hyundai Azera BaseFACTORY OEM SERVICE PROCEDURE

Trunk Control

This IPM Trunk describes the following functions:

  • Trunk Release Control Function
  • Trunk Status Indicator Function
  • Trunk Lamp Function
Fig 1: Trunk Control Communication Diagram
G10368885Courtesy of HYUNDAI MOTOR AMERICA
Function Characteristics Name
Signal Label Spec. Designation
Input Logic L_ExternalTrunkSW External Trunk Open Switch
L_RLDRUnlockSW Rear Left Door Unlock Switch
L_RRDRUnlockSW Rear Right Door Unlock Switch
L_TrunkStatus Trunk Switch Status
CAN_B Communication C_ASTUnlockState Assist Door Unlock Switch
C_DRVUnlockState Driver Door Unlock Switch
C_PassiveTrunk_TG Trunk open command by SMK
C_TrunkOpenSW Trunk Open Switch from DDM
CAN_C Communication VS Vehicle Speed Signal
Internal b_BAState Burglar Alarm State is in ARM type state
b_RKETrunkCmd RKE Trunk Command
Output Logic O_TrunkLamp Trunk Lamp Output
O_TrunkRelease Trunk Release Output
CAN_C Communication CF_Gway_TrkOpnInd Trunk opening Status
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.