Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2015 Hyundai Genesis 5.0FACTORY OEM SERVICE PROCEDURE

Repair procedures: Removal

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the intake manifold.
(Refer to "INTAKE MANIFOLD ")
Disconnect the knock sensor connector (A).
Bank 1

Fig 1: Knock Sensor Connector (Bank 1)
Courtesy of HYUNDAI MOTOR AMERICA

Bank 2

Fig 2: Knock Sensor Connector (Bank 2)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the cross over fuel pipe (A).

Fig 3: Cross Over Fuel Pipe
Courtesy of HYUNDAI MOTOR AMERICA
Remove the installation bolt (A), and then remove the sensor from the cylinder block.

Fig 4: Knock Sensor Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA

Chapter Navigation

Return to Chapter: Repair procedures

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.