2015 Hyundai Equus SignatureFACTORY OEM SERVICE PROCEDURE

Smart Key Unit

  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad lower panel after loosening the mounting screws.

    (Refer to "CRASH PAD LOWER PANEL ")

  3. Disconnect the connector (A) from smart key unit, BCM and tilt & telescopic unit.
    Fig 1: Smart Key Unit Connector
    G10386973Courtesy of HYUNDAI MOTOR AMERICA
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.