Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2015 Hyundai Azera BaseFACTORY OEM SERVICE PROCEDURE

Repair procedures: Removal

Remove the center console assembly.
(Refer to "FLOOR CONSOLE ")
Remove the duct (A).

Fig 1: Center Console Assembly Duct
Courtesy of HYUNDAI MOTOR AMERICA
Remove the control cable (B).

Fig 2: Control Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the control cable assembly in the vehicle after removing the nuts (B) and the retainer (A).
Tightening torque:

9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.9 lb-ft)

Fig 3: Removing Control Cable Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the nut (C).
Remove the cable (B) from the bracket (A) at transaxle assembly side.
(Refer to "AUTOMATIC TRANSAXLE ")

Fig 4: Transaxle Assembly, Cable And Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Remove the control cable inside of cab.

Chapter Navigation

Return to Chapter: Repair procedures

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.