Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Hyundai Veloster Turbo, Automatic TransFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Adjustment
Adjusting method for T/M control cable
- Set room side shift lever and T/M side manual control lever to "N" position.
- Connect room side shift lever and shift cable.
- Push cable to "F" direction illustrated to eliminate FREE PLAY.
- Tighten adjusting nut (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
- After adjusting according check to be sure that this part operates surely at each range of T/M side corresponding to each position of shift lever.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.