SYS.OK|MANUAL.DB● LIVE
2014 Hyundai Veloster Turbo, Automatic Trans

Quick Lookups: Fluids

2014 Hyundai Veloster Turbo, Automatic TransSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 4.40 OZS. 0.13 L PAG 46 S
Air Cond Refrigerant 0.93 LBS. 0.42 KG R-134a S
Automatic Transmission Fluid Automatic Trans 7.50 QTS. 7.09 L MICHANG ATF SP-IV. SK ATF SP-IV. NOCA ATF SP-IV. HUYNDAI genuine ATF SP-IV S
Brake Fluid 0.70 QTS. 0.66 L FMVSS116 DOT 3 or DOT 4 Brake Fluid As required. S
Clutch Fluid 0.70 QTS. 0.66 L FMVSS116 DOT 3 or DOT 4 Brake Fluid As required. S
Engine Coolant Automatic Trans 5.50 QTS. 5.2 L 50/50 mixture of Ethylene Glycol base coolant for aluminum radiator and water S
Engine Oil Turbocharger Drain and Refill,w/Filter 4.80 QTS. 4.54 L API - SM, ILSAC GF-4 or Above, SAE 5W-30, SAE 5W-40. For better fuel economy, it is recommended to use SAE 5W-20. SAE10W-30 Above 0Deg. F (-18Deg C) If API service SM engine oil is not available you may use API service SL. For better fuel economy, it is recommended to use the engine oil of a viscosity grade SAE 5W-30 (API SM / ILSAC GF-4 / ACEA A5 or above). Hyundai recommends Quaker State. S
Fuel Tank 13.20 GALS. 49.96 L S
Manual Transmission Fluid Turbocharger 2.11 QTS. 1.99 L HYUNDAI Genuine Transaxle Fluid. API GL-4, SAE 75W-85 Use Manual Transaxle Fluid approved by HYUNDAI motor company. HK MTF (SK), HD MTF (H.K.SHELL) HYUNDAI Genuine transaxle fluid. S
Windshield Washer Fluid N/A N/A Use a good quality windshield washer fluid, diluted with water as necessary. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.