Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER RE:FLEXREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSDUAL CLUTCH TRANSMISSION CONTROL SYSTEMDCT CONTROL MODULE (TCM)REPAIR PROCEDURESREPLACEMENT
2014 Hyundai Veloster RE:FLEX
Repair Procedures: Replacement
2014 Hyundai Veloster RE:FLEXSECTION Replacement
- Turn off the ignition switch and then disconnect the battery (-) cable.
- Remove the lower cover on the crash pad.
(Refer to the CRASH PAD .
- Disconnect the TCM connector (A).
- Remove the mounting bolt and nut. Then remove the TCM (B).
TCM mounting bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
- Installation is the reverse of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.