SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER RE:FLEXREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 19 (AUTOMATIC TRANSAXLE CONTROL SYSTEM)TRANSAXLE OIL TEMPERATURE SENSORREPAIR PROCEDURESREMOVAL
2014 Hyundai Veloster RE:FLEX

Repair Procedures: Removal

2014 Hyundai Veloster RE:FLEXSECTION Removal
WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery and the battery tray.

    (Refer to "BATTERY ")

  2. Remove the under cover.
  3. Drain the coolant.

    (Refer to "COOLANT ")

  4. Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.

    Tightening torque: 

    38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)

    Fig 1: Identifying Drain Plug
    G09150601Courtesy of HYUNDAI MOTOR AMERICA
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.