Throttle Position Sensor (TPS)

2014 Hyundai Veloster RE:FLEXSECTION Throttle Position Sensor (TPS)
  1. Connect the GDS on the Data Link Connector (DLC).
  2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
    Throttle angle(Β°) Output Voltage (V)
    TPS1 TPS2
    C.T 0.5 4.5
    W.O.T 4.41 0.59
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.