Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER RE:FLEXREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSPOWER WINDOWSPOWER WINDOW SWITCHREPAIR PROCEDURESINSPECTIONPOWER WINDOW MAIN SWITCH INSPECTION
2014 Hyundai Veloster RE:FLEX
Power Window Main Switch Inspection
2014 Hyundai Veloster RE:FLEXSECTION Power Window Main Switch Inspection
- Disconnect the negative (-) battery terminal.
- Remove the front door trim panel.
(Refer to "FRONT DOOR ")
- Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.