SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER RE:FLEXREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSSMART KEY SYSTEMSMART KEY UNITREPAIR PROCEDURESINSPECTIONTAILGATE SWITCH
2014 Hyundai Veloster RE:FLEX

Tailgate Switch

2014 Hyundai Veloster RE:FLEXSECTION Tailgate Switch
  1. Check for continuity between the Trunk lid open switch terminals.

    [with Back View Camera] 

    Fig 1: Identifying Trunk Lid Open Switch Connector Terminals (With Back View Camera)
    G09134483Courtesy of HYUNDAI MOTOR AMERICA
    1. Ground
    2. Tailgate switch

    [without Back View Camera] 

    Fig 2: Identifying Trunk Lid Open Switch Connector Terminals (Without Back View Camera)
    G09134484Courtesy of HYUNDAI MOTOR AMERICA
    1. Ground (Tailgate)
    2. Tailgate switch
    3. Ground (Back View Camera)
    4. Power
    5. V-OUT
    6. V-GND
  2. If continuity is not specified, inspect the switch
    Fig 3: Trunk Lid Open Switch Connector Terminals Continuity Reference Chart
    G09134485Courtesy of HYUNDAI MOTOR AMERICA
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.