SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER BASE, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSAUDIO/VIDEO/NAVIGATION (AVN) SYSTEMAVN REMOTE CONTROLREPAIR PROCEDURESINSPECTION
2014 Hyundai Veloster Base, Standard Trans

Repair Procedures: Inspection

2014 Hyundai Veloster Base, Standard TransSECTION Inspection
  1. Check the audio remote control switch (A) for resistance between connector terminals in each switch position.

    [LH-AUDIO] 

    Fig 1: Identifying Audio Remote Control Switch (LH-Audio)
    G09134421Courtesy of HYUNDAI MOTOR AMERICA

    [RH-TRIP] 

    Fig 2: Identifying Audio Remote Control Switch (LH-Trip)
    G09134422Courtesy of HYUNDAI MOTOR AMERICA
    CONNECTOR TERMINAL SPECIFICATION (AUDIO)

    Switch Connector terminal Resistance
    (±5%)
    Seek up 3-5 430 Ω
    Seek down 3-5 1.11 kΩ
    Mode 3-5 2.11 kΩ
    Volume up 3-5 4.61 kΩ
    Volume down 3-5 6.81 kΩ
    CONNECTOR TERMINAL SPECIFICATION (CRUISE)

    Switch Connector terminal Resistance
    (±5%)
    ON/OFF 3-4 880 Ω
    Cancel 3-4 180 Ω
    SET - 3-4 330 Ω
    SET + 3-4 550 Ω
    CONNECTOR TERMINAL SPECIFICATION (BLUETOOTH + VOICE)

    Switch Connector terminal Resistance
    (±5%)
    Voice 3-4 10.71 kΩ
    End of call 3-4 18.91 kΩ
    Send 3-4 40.91 kΩ
    CONNECTOR TERMINAL SPECIFICATION (TRIP + RESET)

    Switch Connector terminal Resistance
    (±5%)
    Trip 3-4 2.54 kΩ
    Reset 3-4 5.54 kΩ
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.