Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER BASE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSPOWER WINDOWSPOWER WINDOW SWITCHREPAIR PROCEDURESINSPECTIONPOWER WINDOW MAIN SWITCH INSPECTION
2014 Hyundai Veloster Base, Standard Trans
Power Window Main Switch Inspection
2014 Hyundai Veloster Base, Standard TransSECTION Power Window Main Switch Inspection
- Disconnect the negative (-) battery terminal.
- Remove the front door trim panel.
(Refer to "FRONT DOOR ")
- Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.