SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2014VELOSTER BASE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSSMART KEY SYSTEMSMART KEY UNITREPAIR PROCEDURESINSPECTIONTAILGATE SWITCH
2014 Hyundai Veloster Base, Standard Trans

Tailgate Switch

2014 Hyundai Veloster Base, Standard TransSECTION Tailgate Switch
  1. Check for continuity between the Trunk lid open switch terminals.

    [with Back View Camera] 

    Fig 1: Identifying Trunk Lid Open Switch Connector Terminals (With Back View Camera)
    G09134483Courtesy of HYUNDAI MOTOR AMERICA
    1. Ground
    2. Tailgate switch

    [without Back View Camera] 

    Fig 2: Identifying Trunk Lid Open Switch Connector Terminals (Without Back View Camera)
    G09134484Courtesy of HYUNDAI MOTOR AMERICA
    1. Ground (Tailgate)
    2. Tailgate switch
    3. Ground (Back View Camera)
    4. Power
    5. V-OUT
    6. V-GND
  2. If continuity is not specified, inspect the switch
    Fig 3: Trunk Lid Open Switch Connector Terminals Continuity Reference Chart
    G09134485Courtesy of HYUNDAI MOTOR AMERICA
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.