2014 Hyundai Santa Fe XL BaseFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Lift the vehicle.
  3. Disconnect the canister close valve extension connector (A).
    Fig 1: Identifying Canister Close Valve Extension Connector
    G09270839Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the vapor tube quick-connector (A) from the canister.
  5. Disconnect the ventilation tube quick-connector (B) from the fuel tank air filter.
  6. Remove the canister assembly (C) after removing the mounting bolts and nut.
    Fig 2: Identifying Vapor Tube Quick-Connector And Ventilation Tube Quick-Connector
    G09270840Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.