Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2014SANTA FE GLS, FWDREPAIR AND DIAGNOSISTRANSMISSIONTRANSMISSION CONTROL SYSTEMSAUTOMATIC TRANSAXLE CONTROL SYSTEMINHIBITOR SWITCHSPECIFICATIONS

2014 Hyundai Santa Fe GLS, FWD

Inhibitor Switch: Specifications

2014 Hyundai Santa Fe GLS, FWDSECTION Specifications

Type: Combination of output signals from 4 terminals
Specifications

Power supply (V)	12
Output type	Pin to Pin

Signal Code Table

	P	P-R	R	R-N	N	N-D	D
S1	12V	12V	0	0	0	0	0
S2	0	12V	12V	12V	0	0	0
S3	0	0	0	12V	12V	12V	0
S4	0	0	0	0	0	12V	12V

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.